Are you planning to install a Polaris Pulse Bar on your off-road vehicle? If so, you need to understand how the wiring system works. The Pulse Bar is a wiring harness that supplies electrical power to accessories such as lights, audio system, and winches. This article provides a comprehensive guide on the Polaris Pulse Bar wiring diagram.
What is a Polaris Pulse Bar?
To understand the wiring diagram, you first need to know what a Polaris Pulse Bar is. It is an electrical power distribution system that allows you to connect up to six electrical accessories to your off-road vehicle. The system provides a safe and efficient way to power different accessories without compromising the vehicle’s electrical system. The Pulsar Bar works by tapping into the vehicle’s charging system, which creates a consistent power supply for your accessories. Each accessory is connected to a pre-wired harness that plugs into the Pulse Bar. The system is designed to prevent overloading and short-circuiting, which can cause a system failure.
Wiring Diagram Components
The Polaris Pulse Bar wiring diagram consists of several components, which includes the Pulse Bar, Main Harness, Switch Harness, and individual accessory harnesses. Each component plays a significant role in the overall functionality of the system. The Pulse Bar is the central unit that serves as the power distribution hub for all other components. The Main Harness is the primary wire that runs from the Pulse Bar to the battery, while the Switch Harness is the controller that connects to the Pulse Bar and all accessories. The individual accessory harnesses connect each accessory to the Switch Harness, and they are color-coded for easy identification. The wiring diagram also includes several fuses and relays that protect the system from power surges and voltage fluctuations.
Wiring Instructions
To begin installing the Polaris Pulse Bar, you need to disconnect the battery and remove the seat. Locate the Pulse Bar and mount it in a suitable location, preferably near the battery. Then, connect the Main Harness to the Pulse Bar and attach the other end to the battery. Next, install the Switch Harness and connect it to the Pulse Bar. The Switch Harness should be mounted in a convenient location where you can easily access it while driving. Then, connect each accessory harness to the Switch Harness by matching the colors. Once all accessories are connected, inspect the entire system for any loose or damaged wires. Then, reconnect the battery and test the system to ensure it’s working correctly.
FAQs
What Accessories Can I Connect to the Pulse Bar?
The Polaris Pulse Bar is designed to connect electrical accessories such as lights, audio system, and winches. You can connect up to six accessories to the system, depending on their power requirements.
What Size Fuse Should I Use for the Pulse Bar?
The recommended fuse size for the Pulse Bar is 30 amps. However, it would be best to check the individual accessory requirements to ensure you use the correct fuse size.
Can I Install the Pulse Bar on Any Vehicle?
The Polaris Pulse Bar is designed for off-road vehicles such as ATVs and UTVs. However, you can install it on any 12-volt vehicle as long as the electrical system can handle the additional load.
Conclusion
The Polaris Pulse Bar is an essential component for powering different accessories on your off-road vehicle. Understanding the wiring diagram is crucial when installing the system to prevent electrical failures and ensure optimal performance. By following the instructions outlined in this article, you can install the Pulse Bar efficiently and effectively.
