Golf Cart Turn Signal Wiring Diagram

Golf Cart Turn Signal Wiring Diagram

Golf carts are a convenient and fun way to get around the golf course or your neighbourhood. But it’s important to ensure that they are safe to use. One way to increase safety is by installing turn signals on your golf cart. In this article, we will provide you with a golf cart turn signal wiring diagram that will help you with the installation process.

Benefits of Installing Turn Signals on Your Golf Cart

Installing turn signals on your golf cart has several benefits:

  • Increased safety: Turn signals alert other drivers and pedestrians of your intended direction.
  • Legal compliance: Depending on your state or province, it may be mandatory to have turn signals on your golf cart.
  • Convenience: Turn signals make it easier for you to communicate your intended direction of travel, especially in busy areas.

What You Will Need

Before you get started with the installation process, you will need the following tools and supplies:

  • Wiring diagram
  • Turn signal kit
  • Wire strippers
  • Electrical tape
  • Wire connectors
  • Wire loom
  • Crimp tool
  • Screwdrivers
  • Drill

Installation Process

Follow these steps to install turn signals on your golf cart:

Step 1: Prepare Your Golf Cart

Before you begin the installation process, ensure that your golf cart is turned off and the key has been removed from the ignition. You should also disconnect the battery to prevent any electrical mishaps.

Step 2: Mount the Turn Signal Switch

Mount the turn signal switch in a convenient location on your golf cart. The most common location is the dash area. Use a drill to make holes for the screws, and then mount the switch securely.

Step 3: Wire the Brake Light Switch

The brake light switch is an important part of your turn signal system. It activates the brake lights when you apply the brakes. Connect the brake light switch wires to the brake pedal or the brake cable.

Step 4: Wire the Turn Signal Flasher

The turn signal flasher is responsible for making the turn signals flash on and off. Connect the turn signal flasher wires to the turn signal switch and the power source.

Step 5: Wire the Turn Signal Lights

The turn signal lights indicate your intended direction of travel. Mount the lights in a convenient location on your golf cart, such as the front and rear bumpers or the roof. Connect the turn signal light wires to the turn signal switch and the power source.

Step 6: Test the System

Before using your golf cart with the new turn signal system, test the system to ensure it is functioning correctly. Turn on the ignition and activate both turn signals. The lights should blink on and off. If they do not, refer to the wiring diagram for troubleshooting tips.

Frequently Asked Questions (FAQ)

Q: Do I need to install turn signals on my golf cart?

A: Depending on your state or province, it may be mandatory to have turn signals on your golf cart. Check with your local authorities to ensure compliance.

Q: Can I install turn signals on my gas-powered golf cart?

A: Yes, you can. The installation process is the same for both electric and gas-powered golf carts.

Q: Where can I find a golf cart turn signal kit?

A: Golf cart turn signal kits are available at most golf cart dealerships, online retailers, and automotive stores.

Wire Colour Function
Black Ground
Yellow Power
Green Right turn signal
Red Left turn signal
White Brake light