If you’re looking to upgrade the sound of your guitar, the EMG DG20 pickups may just be the perfect solution for you. These pickups are known for their clear, clean sound, and high output. However, figuring out how to install them can be a bit of a challenge. That’s why we’ve put together this comprehensive guide on how to wire your EMG DG20 pickups. We’ll cover everything you need to know, from the parts you’ll need to the step-by-step process of installation.
What You’ll Need
Before you get started on wiring your EMG DG20 pickups, you’ll need to gather a few items. Here’s a list of everything you’ll need:
| Item | Quantity |
|---|---|
| EMG DG20 pickups | 3 |
| EMG solderless wiring kit | 1 |
| Soldering iron | 1 |
| Screwdrivers | 2 |
| Wire cutters/strippers | 1 |
Step-by-Step Wiring Process
Now that you’ve gathered all of the necessary items, it’s time to start the wiring process. Here’s a step-by-step guide to help you through the process:
Step 1: Remove Old Pickups
The first step in the process is to remove the old pickups from your guitar. Unscrew the old pickups from the pickguard or body of your guitar and then gently pull them out.
Step 2: Install EMG DG20 Pickups
Next, install the EMG DG20 pickups. Place the pickups in the same location as the old pickups and screw them into place.
Step 3: Install Solderless Wiring Kit
The next step is to install the solderless wiring kit. This kit will make the wiring process much easier and neater. Follow the instructions that come with the kit to install it correctly.
Step 4: Connect Pickup Wires
Once the wiring kit is installed, it’s time to connect the pickup wires. Each pickup should have a red wire and a white wire. Connect the red wire to the lead wire of the volume potentiometer and the white wire to the ground.
Step 5: Connect Volume Pot Wires
Next, connect the wires from the volume potentiometer. The lead wire should be connected to the pickup red wire, and the ground wire should be connected to the wiring kit ground.
Step 6: Connect Tone Pot Wires
Finally, it’s time to connect the wires to the tone potentiometer. The lead wire should be connected to the pickup white wire, and the ground wire should be connected to the wiring kit ground.
FAQ
1. Can I install EMG DG20 pickups on my own?
Yes, you can install EMG DG20 pickups on your own, but it requires some basic knowledge of wiring and soldering.
2. What is a solderless wiring kit?
A solderless wiring kit is a pre-built wiring harness that allows you to connect your pickups to your volume and tone potentiometers without the need for any soldering.
3. How do I know which wire is the lead wire on my potentiometers?
The lead wire is usually the one that is connected to the center lug of the potentiometer. The ground wire is usually connected to the casing of the potentiometer.
4. Do I need any special tools to install EMG DG20 pickups?
You will need a soldering iron and wire cutters/strippers, but otherwise, the tools needed are pretty basic and can be found in most toolkits.
5. How do I adjust the sound of my EMG DG20 pickups?
You can adjust the sound of your pickups by adjusting the height of the pickups, the tone and volume controls, and by using different types of strings and picks.
With this guide, you should now have all the information you need to wire your EMG DG20 pickups. It’s a process that requires some patience and attention to detail, but the end result will be worth it: a guitar that sounds better than ever before.
