Club Car Precedent is a popular golf cart used in many golf courses and resorts. It is a reliable and efficient vehicle that can provide years of hassle-free service. However, like any other vehicle, it may encounter problems that require some repairs or replacement of parts. One of the most common problems with a Club Car Precedent is a faulty ignition switch. This article will guide you through the process of wiring a new ignition switch to your golf cart.
What is an ignition switch?
An ignition switch is a device that starts and stops the engine of a vehicle. It typically consists of a key-operated switch that controls a series of circuits that send power from the battery to the starter motor, fuel pump, and other essential components. In a golf cart, the ignition switch is usually located under the dashboard or on the steering column.
How does an ignition switch work?
When you turn the key in the ignition switch, it completes a circuit that sends power from the battery to the starter motor. The starter motor then turns the engine over, allowing it to start. When you release the key, the switch returns to its normal position, cutting off the power to the starter motor and allowing the engine to run on its own.
What are the symptoms of a faulty ignition switch?
There are several signs that your ignition switch may be faulty. These include:
| Symptom | Cause | Solution |
|---|---|---|
| The engine won’t start | The switch is not making contact with the circuits | Replace the switch |
| The engine starts, but immediately turns off | The switch is not maintaining contact with the circuits | Replace the switch |
| The engine starts, but won’t turn off | The switch is not cutting off power to the circuits | Replace the switch |
How to wire a new ignition switch?
Step 1: Disconnect the battery
Before you start working on your golf cart, always disconnect the battery to avoid any electrical hazards. Locate the battery and remove the negative cable.
Step 2: Remove the old ignition switch
Using a wrench or pliers, loosen and remove the nut that holds the ignition switch in place. Then, carefully remove the switch from its mounting bracket.
Step 3: Identify the wires
There are usually four wires connected to an ignition switch. The red wire is the main power supply, the yellow or yellow/red wire goes to the starter solenoid, the green or green/white wire goes to the brake light switch, and the black wire is the ground wire. Take note of which wire goes where before removing them, to avoid confusion later on.
Step 4: Connect the new ignition switch
Using the wiring diagram that came with your new ignition switch, connect the wires to their corresponding terminals on the switch. Make sure to tighten the nuts securely to prevent any loose connections.
Step 5: Install the new ignition switch
Once the new ignition switch is properly wired, carefully insert it into the mounting bracket and secure it in place with the nut you removed earlier.
Step 6: Test the new ignition switch
Reconnect the battery and test the new ignition switch. Turn the key to the “on” position and listen for the sound of the fuel pump priming. Then, turn the key to the “start” position and listen for the sound of the engine turning over. If everything is working properly, the engine should start without any problems.
Conclusion
Wiring a new ignition switch to your Club Car Precedent is a relatively easy task that can save you a lot of money in repair costs. By following the steps outlined in this article and using the wiring diagram provided with your new ignition switch, you can have your golf cart back up and running in no time.
