If you’re looking for a 2003 Mitsubishi Outlander radio wiring diagram, you’ve come to the right place. In this article, we’ll provide you with all the information you need to install or replace your Outlander’s radio. We’ll cover everything from the basic wiring diagram to frequently asked questions.
Basic Wiring Diagram
| Wire Color | Function |
|---|---|
| Yellow | Constant 12V+ |
| Red/Black | Switched 12V+ |
| Blue | Power Antenna |
| Black | Ground |
| Gray | Front Left Speaker (+) |
| Gray/Black | Front Left Speaker (-) |
| White | Front Right Speaker (+) |
| White/Black | Front Right Speaker (-) |
| Green | Rear Left Speaker (+) |
| Green/Black | Rear Left Speaker (-) |
| Purple | Rear Right Speaker (+) |
| Purple/Black | Rear Right Speaker (-) |
The 2003 Mitsubishi Outlander radio wiring diagram is pretty straightforward. There are only a few wires you need to worry about, which makes installation or replacement much easier. The yellow wire provides constant 12V+ power to the radio, while the red/black wire is for switched 12V+ power. The blue wire is for power antenna, and the black wire is for ground.
The gray and white wires are for the front left and right speakers, respectively. The green and purple wires are for the rear left and right speakers, respectively. The wires with a black stripe are the negative or ground wires for each speaker.
Installation
Installation of a new radio in your 2003 Mitsubishi Outlander is relatively simple. First, remove the existing radio by using a radio removal tool or a flathead screwdriver to carefully pry the radio out of the dash. Once the radio is removed, disconnect the wiring harness and antenna cable from the back of the radio.
Next, connect the wiring harness and antenna cable to your new radio. Make sure to match the wires from the new radio to the corresponding wires in the wiring harness. Then, slide the new radio into the dash until it snaps into place. Finally, test the new radio to make sure it’s working properly.
FAQ
Q: How do I know if my Outlander has a factory amplifier?
A: If your Outlander has a factory amplifier, it will be located under the passenger seat. You can also check the wiring diagram to see if there are any additional wires for the amplifier.
Q: Can I install a subwoofer in my Outlander?
A: Yes, you can install a subwoofer in your Outlander. You’ll need to tap into the rear speaker wires and run additional wiring to the subwoofer.
Q: How do I remove the factory radio?
A: To remove the factory radio, you’ll need a radio removal tool or a flathead screwdriver. Insert the tool or screwdriver into the four holes in the corners of the radio faceplate and gently pry the radio out of the dash.
Q: What size are the speakers in my Outlander?
A: The front and rear speakers in the 2003 Mitsubishi Outlander are 6.5 inches in diameter.
Q: Can I use an aftermarket radio with my Outlander’s steering wheel controls?
A: Yes, you can use an aftermarket radio with your Outlander’s steering wheel controls, but you’ll need a steering wheel control adapter. The adapter will allow your new radio to communicate with the steering wheel controls.
That’s all the information you need to install or replace the radio in your 2003 Mitsubishi Outlander. Follow the wiring diagram, and you’ll have your new radio up and running in no time.
