If you recently purchased a 2019 Silverado and want to upgrade your audio system, you’ll need to know the wiring diagram for the speakers. This article will provide you with all the information you need to install new speakers or replace old ones. We’ll cover the basics of speaker wiring, as well as some frequently asked questions about the 2019 Silverado speakers.
Speaker Wiring Basics
The wiring diagram for the 2019 Silverado speakers is relatively simple, but it’s important to understand a few basic concepts before you start the installation process. Here are the key things you need to know:
Speaker Wire Colors
The speaker wire colors in the 2019 Silverado are as follows:
| Speaker | Wire Color |
|---|---|
| Front Left | Tan |
| Front Right | Light Green |
| Rear Left | Brown |
| Rear Right | Yellow |
Note that these wire colors may vary slightly depending on your specific Silverado model and trim level. Always verify the colors with a wiring diagram or a multimeter.
Impedance
The impedance of your speakers should match the impedance of your amplifier or head unit. The 2019 Silverado speakers have a nominal impedance of 4 ohms. If you’re installing new speakers, make sure they also have a nominal impedance of 4 ohms. Using speakers with a lower impedance can damage your amplifier or head unit.
Polarity
The polarity of your speakers is also important. If the positive and negative terminals of a speaker are reversed, the speaker will be out of phase with the other speakers in your system. This can cause a loss of bass or a decrease in overall sound quality. Use a multimeter or a wiring diagram to verify the polarity of your speakers before connecting them to your amplifier or head unit.
Mounting Depth
The 2019 Silverado speakers have a mounting depth of approximately 3.5 inches. Make sure your new speakers have a similar mounting depth or that you have enough clearance in your doors or rear deck to accommodate deeper speakers.
Speaker Size
The 2019 Silverado comes with several different speaker sizes, depending on the trim level and options. The front speakers are typically 6.5 inches, while the rear speakers are usually 4 inches or 6×9 inches. If you’re not sure what size speakers you have, check the owner’s manual or remove the factory speakers to measure them.
FAQ
Can I use aftermarket speakers with my 2019 Silverado?
Yes, you can use aftermarket speakers with your 2019 Silverado. Just make sure they have a nominal impedance of 4 ohms and the correct mounting depth and size for your specific Silverado model and trim level.
Do I need to use an external amplifier?
Not necessarily. The 2019 Silverado comes with a factory amplifier or head unit that can power the speakers adequately. However, if you want to achieve better sound quality or higher volume levels, you may want to consider using an external amplifier.
How do I remove the factory speakers?
Removing the factory speakers in your 2019 Silverado will vary depending on the location and type of speaker. However, in general, you’ll need to remove the door panel or rear deck cover and unscrew any mounting screws or clips holding the speaker in place. Disconnect the speaker wires and remove the speaker from the vehicle.
What tools do I need for speaker installation?
You’ll typically need a socket wrench, screwdriver, wire crimpers, wire strippers, and possibly a panel removal tool to install new speakers in your 2019 Silverado. It’s also a good idea to have some electrical tape or heat shrink tubing to insulate the speaker wire connections.
What’s the best way to improve my Silverado’s sound system?
Upgrading your speakers is a great way to improve the sound quality of your 2019 Silverado’s audio system. You can also consider replacing the factory amplifier or head unit, adding a subwoofer, or sound deadening the doors and rear deck to reduce road noise.
By following the information and tips provided in this article, you should be able to install new speakers in your 2019 Silverado and enjoy improved sound quality and a better listening experience.
