Are you curious about the wiring diagram for the upfitter switches in your 2019 Raptor? Look no further, we have all the information you need right here. In this article, we will guide you through the wiring diagram for the upfitter switches step by step, including frequently asked questions and tables for easy reference.
What are upfitter switches?
Upfitter switches are a set of auxiliary switches located on the center console of your 2019 Raptor. These switches are designed to allow you to easily connect and control aftermarket accessories such as lights, winches, and other electrical components.
The 2019 Raptor comes equipped with up to six upfitter switches, depending on the trim level. These switches are pre-wired and controlled by a body control module (BCM) located under the dash.
Wiring diagram for upfitter switches
The wiring diagram for the upfitter switches in your 2019 Raptor can be broken down into three main components: the power source, the switch, and the accessory.
Power source
The power source for the upfitter switches is provided by two fuses located in the engine compartment fuse box. Fuse F87 provides power to all six switches, while fuse F86 provides power to the second, third, and fourth switches, depending on the trim level.
Once the power is supplied by the fuse, the signal is sent to the BCM. The BCM then sends the signal to the switch.
Switch
The switch is the middleman between the power source and the accessory. When the switch is activated, it sends a signal to the BCM to turn on the accessory. The switch wiring is color-coded as follows:
| Switch | Wire color |
|---|---|
| SW1 | Green/Orange |
| SW2 | Purple/Orange |
| SW3 | Brown/Orange |
| SW4 | Red/Orange |
| SW5 | Blue/Orange |
| SW6 | Yellow/Blue |
It is important to note that the switch wiring may differ depending on the trim level of your 2019 Raptor. Consult your owner’s manual or a certified mechanic for accurate information.
Accessory
The accessory is the final component in the wiring diagram for the upfitter switches. Once the power has been supplied by the fuse and the switch has been activated, the accessory will turn on. The accessory wiring varies depending on the type of aftermarket component you are connecting. It is important to refer to the manufacturer’s instructions for proper wiring.
Frequently asked questions
Can I add more upfitter switches to my 2019 Raptor?
Yes, it is possible to add additional upfitter switches to your 2019 Raptor. However, it is recommended that you consult a certified mechanic to ensure proper installation and wiring.
What happens if I overload the upfitter switches?
If you overload the upfitter switches in your 2019 Raptor, it may cause a fuse to blow or damage the electrical system. It is important to only connect accessories that have a lower amperage than the fuse rating.
Can I control the upfitter switches with my smartphone?
Unfortunately, the upfitter switches in the 2019 Raptor are not compatible with smartphone apps or remote control devices.
How do I troubleshoot issues with my upfitter switches?
If you are experiencing issues with your upfitter switches, such as a switch that is not working or an accessory that is not turning on, consult your owner’s manual or a certified mechanic. It is important to only attempt troubleshooting if you have the proper knowledge and experience.
Conclusion
The wiring diagram for the upfitter switches in your 2019 Raptor may seem complex, but with this guide, you can easily understand and connect aftermarket accessories to your vehicle. Remember to always consult a certified mechanic if you are unsure about any wiring or installation processes.
